Skip to content
Maitland Concrete Works
  1. Home
  2. Services
  3. Concrete removal and replacement

Concrete removal and replacement in Maitland and the Hunter

The driveway that dropped at the kerb, the path that lifted at every joint, the patio that cracked the first summer. Old concrete comes out, the ground underneath gets fixed, and the new slab goes in on a base that will hold it. Removal is priced as an add to the new pour.

Added to the new pour about $35per m²
  • Single driveway, 36 m²+$1,250
  • Double driveway, 60 m²+$2,100
  • Patio and path, 40 m²+$1,400
Formwork boxed and steel set out on a corrected base, Aberglasslyn
Formwork boxed and steel set out on a corrected base, Aberglasslyn

Concrete around Maitland fails in ways you can read from the footpath. On the floodplain streets of Maitland, East Maitland, Tenambit and Raymond Terrace the driveway has dropped at the kerb and lifted at the house, because the river clay under it has swollen and shrunk through decades of wet and dry seasons. In Rutherford and Cessnock the 1960s and 1970s slabs were poured thin, unreinforced or straight onto topsoil, and have broken into plates. In the newer estates the failure is a builder’s driveway poured on uncompacted fill, cracked within the first summer. The fix in every case is the same: out, fix the ground, back in properly.

What removal involves

The old slab is broken up with a breaker or a small excavator, loaded and carted to a recycler, and the ground underneath is exposed for the first time in a generation. That is when the real cause shows: soft clay, a buried stump, an old rubble base that was never compacted, a downpipe that has been discharging under the slab. The base is dug to firm material, corrected, compacted and shaped to drain, and only then does the new pour go in to the specification. Removal adds about $35 per m² to the new rate.

Why overlaying is a false saving

A topping laid over a cracked slab looks new for about as long as it takes the ground to move again, and it raises every level around it. The garage door no longer clears, the kerb transition steepens, and water that used to run to the street now runs to the house. Councils will not accept a topping on their crossing either. Replacement costs more on the day and is the last time you pay for that driveway.

The crossing

Replacing a driveway nearly always means replacing the crossing, and the crossing is council’s. Maitland City Council and Cessnock City Council both list repairs and restoration of an existing crossing as needing Section 138 consent, and Port Stephens Council’s form covers reconstruction. That means an application before the pour, a fee, and in Maitland and Cessnock an inspection of the formwork. The Section 138 guide has each council’s process and fee.

What goes back in

Whatever the site should have had the first time: a driveway in plain, coloured or exposed aggregate, a path that falls away from the house, a patio jointed away from the dwelling, or a shed slab with the thickened edges the old one never had. Doing the removal and the new pour as one job with one crew is the cheapest way to have both.

Add removal in the calculator, read the cost guide for what moves the figure, then ask for a measure.

Rates on this site are guide figures for planning a budget. Your price is the written quote after the concreter has seen the block, and it can sit outside the guide where ground, access or a small area call for it.

Questions

Concrete removal and replacement: the questions

What does it cost to remove and replace a concrete driveway in Maitland?

Removal adds about $35 per square metre to the rate for the new pour. A 36 square metre single driveway in plain concrete therefore brackets at roughly $4,700 to $5,900 all up, and a 60 square metre double in exposed aggregate at $9,900 to $13,200. Access for the excavator and the truck, and the state of the ground once the old slab is up, are the two things the site visit settles.

Why not just pour new concrete over the old driveway?

Because the old slab failed for a reason, and the reason is still there. A thin overlay bonded to a moving base cracks along the same lines within a season or two, and it raises the levels at the garage door, the kerb and the house so water runs the wrong way. Taking the old concrete out lets the base be dug to firm ground, compacted and shaped to drain, which is what the first pour should have had.

Do I need council approval to replace my driveway crossing?

Yes, for the strip between your boundary and the kerb, in all three council areas, even like for like. Maitland City Council and Cessnock City Council both list repairs and restoration of an existing crossing as needing Section 138 consent, and Port Stephens Council's form covers reconstructing a driveway. Replacing concrete inside your own boundary needs no road approval.

How long does removal and replacement take?

Typically a day to break out and cart, a day to prepare the base and form up, the pour, and then curing. Most concreters ask for about a week before cars use a new driveway, longer in cold weather, so plan on parking on the street for a fortnight. Where the council crossing is part of the job, the approval comes first and Maitland and Cessnock both inspect the formwork before the pour.

Next step

Book the site visit

Maitland Concrete Works is a referral service. Each enquiry goes to one independent concreter working the Maitland, Cessnock and Port Stephens council areas, who visits the block, measures, quotes in writing and does the work.

Get it measured and quoted

Tell us what is being poured and the suburb. An independent local concreter rings you back to book the site visit.

Or ring (02) 4012 6377

Call (02) 4012 6377 Get a quote